Provides 5 1/2 inches of setback from the boat transom to achieve its full potential.
84 degrees of tilt and trim from the transom.
Fabricated from 1/4 inch 6061 T6 extruded aluminum and attached with stainless steel fasteners.
Cannot be used with motors with clamp mounting feet or bolts that have a width of 11 inches of greater.
Accommodates Clamp-on or Bolt-on Motors Without the Need of an Adapter.
Includes up-down toggle switch.
The boater can then move the engine up and down as well as tilting it in and out with the power tilt and trim.
Easily adjustable from top or bottom.
All the necessary electrical components for installation are included.
Hydraulic System Features:
Marine electric hydraulic system is made of 100% non-ferrous material for corrosion resistance in any water.
Hydraulic actuator is completely self contained with its own fluid reservoir.
Hydraulic tank and hoses inside the boat are not necessary.
40% more lifting capacity than other transom tilt trim units on the market.
Quality control guaranteed by computer aided design and precision machining.
NOTE:The inside dimension of the motor mounting area of the PT-35 is 11 inches. Before ordering, please make sure that the maximum width of the clamp mounting feet and/or mounting bolts of the motor that must fit into this area does not exceed this 11 inch limit. If these measurements are more than 11 inches, you will have to go to the PT-130. Mounting bolts are not included with the PT-35.
"Outside the US country: Save on shipping. Please Email Us for a less expensive alternative to UPS."
All CMC Orders received from Thursday (until 1:00 P.M Central Time) to Sunday would be shipped on the next business day (Monday)