Home > CMC Outboard Jack Plate > CMC Hydraulic Jack Plates > PL-65 Hydraulic Jack Plate 65002

PL-65 Hydraulic Jack Plate 65002

Product Description

Hydraulic System Features:

Power lift utilizes Totally waterproof!

Marine electric hydraulic system is made of 100% non-ferrous material rust prevention made by water.

Hydraulic actuator is completely self contained with its own fluid reservoir and has a max. lifting capacity of 7853 pounds of thrust.

Provides more lifting capacity than any other transom jack plates on the market.

No need to use for hydraulic tank, nor will you have to contend with mounting a pump and hoses inside the boat.

Quality control guaranteed by computer aided design and precision machining.

Made of ¾ and ¼ inch 6061 T6 alloy aluminum extrusions and attached with stainless steel fasteners.

Eliminates vibration and shimmy due to loads applied from high power outboards.

Virtually eliminates binding which is common with other transom jacks.

PL-65 Hydraulic Jack Plate Features:

Provides 5 inches of vertical travel with 5 ½ inches of set back.

Ideal for fresh or salt water use. No welds or castings to break.

Adjustable for different speeds, water conditions, and varying loads on your boat.

Rated for V-6 and smaller applications.

You will have an advantage of lifting even a V-6 300 hp max. motor at full throttle.

All necessary electrical components or mounting hardware are included.

Can be purchased with optional lift gauge.

Take a look at the wiring for the PL-65.
PL-65 CATALOG

We recommend using transom washer plates if you plan to mount a V6 or larger motor. The CMC transom washer plates can eliminate embedding of bolt heads into the transom by more evenly distributing loads on high performance engine.

CLICK THE DIAGRAM TO ENLARGE PL-65's DIMENSION:

REMINDER:
CMC Orders received from Friday to Sunday would be shipped on the next business day(Monday)

We ship worldwide. Please Email Us for a less expensive alternative to UPS

Accessories

Pontoon Boat Transom Spacer 13032

The transom on some pontoon boats are inset with an aluminum lip along the sides.

To conveniently mount the PT-130 tilt trim to this type transom, this transom spacer is available.

The pontoon boat transom spacers are 1 inch thick allowing you to mount the PT-130 without interference with the 1/2"ť to 3/4"ť lip around the transom on some pontoon boats.

$43.00

Bottom transom washer plate 20032

This bottom transom washer plate eliminates bolts biting into boat transoms and more evenly distributes loads due to high performance engines. Made of 3/8 6061 T6 aluminum alloy. 9 7/8 hole center to hole center.

$18.50